Hits: 1644 img
With the continuous upgrading of high‑end equipment, avionics and special medical devices, complex working conditions such as ultra‑low temperature, radiation resistance and high damping have put forward higher technical requirements for silicone base gum. As a functional base material for phenyl silicone rubber, methyl‑phenyl‑vinyl silicone gum introduces phenyl groups on molecular chains. While retaining high‑temperature resistance and dielectric properties of methyl‑vinyl silicone rubber, it achieves comprehensive improvement in low‑temperature flexibility, radiation resistance and damping performance, making it a critical raw material for special rubber product development.
This base gum maintains certain flexibility at ‑110℃. It features good storage stability, low volatility, low compression set and resistance to saturated steam. It is insoluble in water and soluble in toluene‑type organic solvents. Phenyl content, vinyl content and vinyl distribution are three core variables determining mechanical, cryogenic and anti‑radiation performance of final vulcanized articles. Formulation selection shall be adjusted according to practical service conditions.
| Item | Specifications |
|---|---|
| Appearance | Colorless gum |
| Phenyl content (Ph/Si) | 5‑40 % |
| Molecular weight(Mw) | 400,000‑800,000 |
| Specific gravity(25℃) | 0.99‑1.05 |
| Volatile content(150℃/3h) | ≤2 % |
| Storage condition | Below 40℃, unopened original package |
| Shelf life | 24 months |
A: No. Low‑phenyl formula shows the best low‑temperature flexibility. Higher phenyl ratio improves damping and radiation resistance yet weakens low‑temperature softness. Trade‑offs shall be made according to actual working conditions.
A: Vinyl‑terminated gum is preferred for superior mechanical strength. Gum with evenly distributed side‑chain vinyl is suitable for better resilience and stable cross‑link density.
A: Shelf‑life is 24 months for sealed original packages stored below 40℃. If abnormal hardening or caking occurs or shelf‑life expires, perform small‑batch vulcanization test before mass production instead of direct feeding.
A: Direct replacement is not recommended. Phenyl modification changes material compatibility, low‑temperature behavior and damping characteristics. Formulation including reinforcing fillers and vulcanizing agents needs re‑validation.
A: Insoluble in water, soluble in aromatic solvents such as toluene. Avoid strong acid or alkali environments to prevent molecular‑chain degradation.