IOTA corporation ltd
Elastomeric materials, only silicone rubber is the safest. According to the FDA certification in the United States, there is currently no new environmentally friendly material that is more harmless to......
2024-02-21The reason why silicone rubber products need to be vulcanized is because after vulcanization, they have higher application value, greatly improved mechanical properties, no change in adhesion, are not......
2024-02-21HTV high-temperature vulcanized silicone rubber is a type of organic silicon product that has excellent resistance to high and low temperatures, UV rays, radiation, weather, electrical insulation, hig......
2024-02-201. Demolding ability The quality of demolding is an important performance of mixed rubber in molding processing. If the demolding is poor, it is easy to cause waste, reduce labor efficiency, pollute ......
2024-02-20The main reasons that affect the elasticity of silicone products are as follows. 1. The formula and quality of raw materials can directly affect the products produced by silicone product manufactur......
2024-02-19Silicone oil is a raw material with many special properties, such as low temperature viscosity coefficient, high and low temperature resistance, oxidation resistance, high flash point, low volatility,......
2024-02-19Under the influence of various external environmental factors such as deformation, oxygen, ozone, light, heat source, water, oil, chemical solvents, etc., silicone sealing rings may fail due to change......
2024-02-18The toxicity of silicone sealing rings after high temperature has always been a concern for people. The following is information about silicone sealing rings: 1. Production raw materials for silico......
2024-02-18When it comes to sealing rings, kitchen utensils, appliances, and many other products in every household cannot do without sealing rings. However, there are various materials of sealing rings on the m......
2024-02-18Silicone rubber is not plastic, and it is also called Silikon or silicone, with different names in different places. It is a combination of sexual materials. There are many types of uses for silicone......
2024-02-18All silicone products are made from raw materials that are subjected to high temperature and high pressure in a mold, and then subjected to vulcanization and oil pressure to produce silicone products.......
2024-02-07Injection point When molding LSR, a cold runner system is used. It can maximize the advantages of this adhesive material and improve production efficiency to the maximum extent. By processing the pro......
2024-02-07Parting line Determining the position of the parting line is one of the first few steps in designing a silicone rubber injection mold. The exhaust is mainly achieved through grooves located on the pa......
2024-02-07The structure of the injection mold for thermosetting liquid silicone rubber (LSR) is generally similar to that of the mold used for thermoplastic materials, but there are also many significant differ......
2024-02-074、 Tear strength The resistance to the expansion of the incision or scratch when applying force to a sample with a incision. Even when cut open and subjected to extremely high torsional stress, the h......
2024-02-07
